New Products!
Glass Sheets
Mailing List Specials
Beginners Kits + Videos
Bevels
Books
Chemicals
Clock Kits
Copper Foils and Tapes
Decals on Glass
Gift Vouchers
Glass Decorations
Glass Fused Eyes
Glass Jewels
Glass Nuggets
Glass Pendants
Glass Raindrops
Grinders & Accessories
Jewellery Box Hardware
Kaleidoscopes
Lamp Fittings & Bases
Lampshade Patterns
Lead Came
Lead Figures
Miscellaneous
Mosaic Accessories
Mosaic Glass Packs
Pressed Metal/Filligree
Soldering Irons & Accessories
Solders
Suncatchers
Tiger Wire & Crimps
Tinned Wire
Tools
|
YOU ARE IN >>> Grinders & Accessories > Diamond Grinder Heads & Drills
Diamond Grinder Heads & Drills
Please note we do not sell any Diamond Heads other than the ORIGINAL Glastar heads...beware of cheap imitations!
" Australian Grinder coolant when added to the water in your grinder, will make grinding easier and prolong the life of your diamond grinding head...it's available in the Chemicals - Miscellaneous section."
|
Diamond Grinding Head - 1/4 Inch Standard Grit
|
|
|
1/4" Glastar Diamond Grinder Head. Permanently " Bonded " surface. Fits all Glastar and Wizling Grinders.
100 grit Head for Standard work.
(N.B. These heads fit directly onto the new quick fit grinders. An adaptor is needed for the non-quick fit grinders. )
|
|
Glastar Radius Grinding Head
|
email for availability
|
|
This head is a combination flat and radius ( rounded ) edger. The center groove will take the sharp edges off all standard art glass.
You also have 4 1/8th inch flat grinding surfaces - two below and two above center. Great for foiling mosaics and any exposed edges.
Select this for mosaics or when working with exposed glass edges. Use the fine grit radius head to virtually eliminate chipping on decorative mirror edging.
|
|
Glastar Ripple Grinder Head
|
email for availability
|
|
This combination head has a tapered channel for heavily textured glass. Makes foiling and fitting this type of glass into lead or zinc came a breeze. Also has 3 regular flat grinding surfaces.
Standard Grit. 100 mesh.
|
|
Glastar Lamp Grinding Head
|
email for availability
|
|
This head has 1 flat and 2 angled surfaces. Use lower (9 degree) surface for lamps with ten or more panels. To use upper (18 degree) surface for lamps with less than ten panels, lower head on motor shaft, then turn piece of glass upside down to grind correct angle.
The flat surface at center may be used for regular flat grinding.
|
|
